MANUFACTURED TO MEET FLAMMABILITY* REQUIREMENTS CONTAINED IN THESE SPECIFICATIONS:
| Requirements | Test Method | Results |
| Weight (ozs./sq. yd.) | ASTM D751-95 | 18.5 +/- 5% |
| Total thickness (inch) | ASTM D751-95 | 0.043 +/- 10% |
| Tensile strength (lbs.) | ASTM D751-95 | L. 88 +/- 10% C. 73 +/- 10% |
| Tear strength (lbs.) | Fed. Spec 191 A Method 513A |
L. 10.5 +/- 2% C. 10.5 +/- 2% |
| Tear strength (lbs.) | ASTM D1117-80 | L. 25 +/- 5% C. 25 +/- 5% |
| Coating adhesion (lbs./inch) | ASTM D751-95 | L. > 3.5 C. > 3.5 |
| Low temperature resistance | ASTM D 1790-94 | -10 F |
| Cracking resistance (wet/dry) | Fed. Std. 191 A Method 3651 |
pass |
| Abrasion resistance (200 cycles/CS- 17) |
Fed. Std. 191 A Method 5306 |
no print wear |
| Flexing resistance (Flex-o-test 15,000 C/S) |
CFFA-10 | pass |
| Accelerated light aging (Fadeomoter 200 hours) |
ASTM G25-75 | pass |
| Blocking resistance | Fed. Std. 191 A Method 5872 |
pass rating 1 |
| Flame retardancy | California Flammability Regulation
117-75 Section E BIFMA Class 1, UFAC Class I |
*Terms and corresponding data refer to performance in the specific test indicated and should not be construed to imply the behavior of this or any material under actual conditions This information is accurate to the best of our knowledge at the time of printing, but is not intended to relieve the user from its responsibility to comply with all procedures applicable to the safe use of this product.
